P-Tex Sticks | 11mm

These P-tex repair sticks come in both clear and black colors in size 11mm. To repair your base you need to first make sure your base is clean of any wax.  Use base cleaner to prep the repair area. Then using a steel scraper or razor blade try and get the area around the gouge flat and clear of any frays of P-tex. Make sure it's a nice smooth surface to bond to. Then using a lighter heat up the P-tex stick to where its on fire like a candle holding the stick at an angle so the material drips off the stick into the gouge. Fill the gouge completely until it's flush with base. Too much is better than not enough. Let the material cool and then using a sharp razor blade carefully cut any additional material that has filled the repair hole so the base is flush.

Colors: Black, Clear

Size: 11mm

11mm P-tex sticks are primarily used for the base extruder gun.